Code of Practice for Piston Air Compressors

Release time:

Aug 08,2024

Source:

Therefore, the oil level should be maintained at all times within the red circle.

Code of Practice for Piston Air Compressors

1, air compressor lubricating oil, generally speaking to high oil quality (Oilness) and contains oxidation Yang agent, not easy to oxidation deterioration, not easy to foam, and carbon residue bottom, high flash point is ideal, because of a variety of common commonly used are.

a 13" compressor oil (winter oil)

b 19" compressor oil (summer oil)

2, Please keep the oil level in the oil mirror in the middle of the red circle range, too much oil in addition to waste of lubricating oil, and easy to make the valve carbonization, too little oil is often due to poor lubrication, and make it burn or wear. Therefore, the oil level should be maintained at all times within the red circle.

3、When the oil color becomes black or there is oil pollution (about every 500 hours), please change the oil once.

4、When changing oil, please open the oil drain plug under the crankcase, use the cardboard or other objects to export the dirty oil, wait for the oil to be poured out, then tighten the oil plug (it is best to apply universal glue or stop leakage paste on the teeth of the oil plug to prevent oil leakage), and then re-fill the oil into the middle of the red circle of the oil mirror after opening the oil filler cap.

5、Don't add new oil when running.

6, Do not use thick lubricating oil and other miscellaneous oil waste oil.

Caveat

1、Check the screws or nuts of each department, whether there is loose phenomenon.

2、Is the belt loosened or tightened appropriately.

3, whether the pipeline is normal, whether the oil level is appropriate.

4、Whether the wires and electrical switches are in accordance with the regulations, and whether the boundaries are correct.

5, each wheel foot pivot point has been or fixed smoothly.

6, compression that the pulley is easy to turn by hand.

7, before the compressor work, it is best to idle for more than 2 to 3 minutes, and then normal operation.

8, check whether the direction of operation and the indicator arrow points to the same, if not the same, three-phase motor, please switch any two of the three power supply can be.

9、Air cleaner should be checked frequently to see if there is any pollution attached, and the filter cotton should be removed and cleaned (with gas oil) or replaced to maintain good air filtration effect.

10, daily in the air compressor after use, should open the barrel drain valve, the barrel of the condensation of water and oil, etc., exclude clean.

11, air compressor cylinder head and copper pipe part, due to air compression and heat, general temperature is very high, this is an inevitable phenomenon is not anomaly.

12、Please cut off the power supply in case of power failure or after using the air compressor during operation to ensure the safety.

Last page

Principle of four-way valve cooling and heating

Differences between diaphragm compressors and conventional compressors